Part Number Hot Search : 
WWQ10 KBP06 DSP56366 1084110 SK170 TCLT1001 APC77176 1148FP
Product Description
Full Text Search
 

To Download PRL0801E-24 Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
  features: compact 300w with 1u height power density: 12.5 watts/cu in 150w ~ 300w ac - dc pfc switching power supply prl0801 single output series product specifications: input voltage: 90 ~ 264vac full range, 47 ~ 63hz. input current: 5a at 90vac. inrush current: max. 70a@230vac & 35a@115vac; cold start. power factor correction: pf>0.95 typical. transient response: returns to within 1% in less than 2.5ms for a 50% load change and the peak transient does not excess 5%. overshoot: turn - on & off overshoot < 5% over nominal voltage. efficiency: 75% ~ 89% depends on model. turn on delay : 1 second maximum at 230 vac. hold up time: 16ms min @ 120vac. at 80% of full load. adjustability : output user adjustable +/ - 5% minimum. fan drive: 12vdc/300ma offering to drive an external fan. fan fail (ff) alarm: designated as ff on pin 3 of cn3, two types of logical signal provided, contact manufacturer. remote on - off: designated as inh on pin4 of cn3, requires a low signal to inhibit output. power supply on: green led designated as led1 on the pcb. power good: pg on cn3 goes high 100 - 500ms after dc regulation and low at least 1ms before loss of regulation (open collector). input fusing protection: one f5a/350v fuse inserted in primary. over - power protection: 110~140% of i - max; auto - recovery. short circuit protection: trip without damage and auto - recovery. switching frequency: pfc 40k~66k hz; pwm 55k~75k hz. over voltage protection: unit latching down when output exceed 130% and recycle ac input to reset. over - temperature protection: unit protected of excessive operating ambient 110 5 , and automatic recovery. warranty: 2 years. vibration: 5 ~ 50 hz, acceleration 7.35 m/s*s on x,y and z axis. operating temperature: 0 to 70 ambient, de - rating at 2.5% per degree from 50 to 70 . storage temperature : - 20 to 85 . operating humidity : 5% to 90% rh, non - condensing. storage humidity: 5% to 95% rh, non - condensing. emc: en55022 class b conducted / radiated, en61000 - 3 - 2, en61000 - 3 - 3; en55024 (iec61000 - 4 - 2, iec61000 - 4 - 3, iec61000 - 4 - 4, iec61000 - 4 - 5, iec61000 - 4 - 6, iec61000 - 4 - 11). safety regulation: ul60950 - 1, en60950 - 1, iec60950 - 1. leakage current: < 1ma @ 264vac. hi - pot test : 1500 vac input line to chassis (10ma dc cut off current); isolating 3000vac primary to secondary windings; primary to core 1500vac. all for 3 sec. grounding test: apply 25 a from ground pin of the three prong plug to the far most earth. max allowable resistance 0.1 ohm. mtbf: 100000 hrs (according to mil - hbk - 217f) at 30 . cooling: u type: u - chassis @300w max. with 25cfm forced airflow; 150w convection cooling (same output ratings w/ top cover option). e type: enclosed with rear side built - in fan @300w max. f type: u - chassis with top built - in fan @300w max. enclosure : u type: 5(l) x 3.2(w) x 1.5(h) inches. u type with top cover option: 5(l) x 3.2(w) x 1.66(h) inches. e type: 6.5(l) x 3.2(w) x 1.6(h) inches. f type: 5(l) x 3.2(w) x 2(h)inches. burn in: 45 +/ - 5 degree c for 1 hour @230vac with full load. weight : maximum u - type weight is 500g. copy right ultra level tech co., ltd 2015, all right reserved. specifications subject to change without notice. cb u type (with top cover): 3.2(w) x 5(l) x 1.66(h) inches. e type (enclosed with end built - in fan): 3.2(w) x 6.5(l) x 1.6(h) inches u type (u - chassis only): 3 .2 ( w ) x 5 ( l ) x 1.5 ( h ) inches. f type (u - chassis with top built - in fan ): 3.2 ( w ) x 5 ( l ) x 2( h ) inches. ultra level tech co., ltd. we supply the power customers need iso9001 www.ultralevel.com.tw tel:+886 - 2 - 29180118 fax:+886 - 2 - 29181465
output voltage / current rating chart: measured at output power connector. note: * prl0801 series are designated as prl0801x - y where x can be e (enclosed type with rear side built - in fan) or f (u - chassis type with top side built - in fan) or u (u - chassis), y can be 05, 09, 12, 15, 18, 24, 30, 36, 40, 48, 54. * u type: u - chassis @300w max. with min. 25cfm forced airflow; 150w under convection cooling (option: vented top cover). * e type: enclosed with rear side built - in fan @300w max. * f type: u - chassis with top built - in fan @300w max. * all output range are covered in agencies certification and the preset voltage will be set as standard models if any request is not preset output then should contact us in advance. * ripple and noise is measured from 10khz to 20mhz bandwidth at output with parallel 0.1f ceramic and 22f electrolytic capa cit ors. * providing peak power to 600w within 500us for all models, longer duty duration need contact manufacture. * 1% minimum load is required to maintain the ripple and regulation. * output is fully isolated. input connector (cn1): u and f type: mating molex part no. vhr - 5n or equivalent (5pin, 3 used), or terminal block: howder m3 screws 3 pin 6.35mm center part no. hd - 601 - 3p; pcb labeling: l=line; n=neutral; g=chassis ground . e type: iec320 snap - in mounting type or terminal block: howder hd - 602 - 3p. output connector (cn2): mating molex part no. vhr - 6n terminal block - dinkle p830n, m5 screws. output pin assignment: (see table in right). mounting inserts: 6paces m3. maximum penetration 3.8mm sees outline drawing for location. logic signal connector (cn3) : mating jst xhp - 4 or equivalent (chyao shiunn js - 2001 - 04); mating pins: jst sxh - 002t - p0.6 for awg 30 to 26. fan driver connector (fan1) : mating connector is jst p/n xhp - 3 (3 pins 0.98 pitch) or equivalent (chyao shiunn js - 2001 - 03). dinkle molex v+: pin 2 v+: pin 4 ~ 6 v - : pin 1 v - : pin 1 ~ 3 outline drawing: copy right ultra level tech co., ltd 2015, all right reserved. specifications subject to change without notice. model output range preset voltage max. output power or current regulation ripple & noise type u & e & f (forced air) type u (convection) prl0801x - 05 2 ~ 5v 5v 42a 20a +/ - 1% 1% prl0801x - 09 7 ~ 11v 9 v 27.27a 13.64a +/ - 1% 1% prl0801x - 12 12 ~ 13.8v 12 v 300w 150w +/ - 1% 1% prl0801x - 15 14 ~ 16v 15 v 300w 150w +/ - 1% 1% prl0801x - 18 17 ~ 22v 18v 300w 150w +/ - 1% 1% prl0801x - 24 23 ~ 28v 24v 300w 150w +/ - 1% 1% prl0801x - 30 29~ 34v 30v 300w 150w +/ - 1% 1% prl0801x - 36 35 ~ 43v 36v 300w 150w +/ - 1% 1% prl0801x - 48 44 ~ 52v 48v 300w 150w +/ - 1% 1% prl0801x - 54 53 ~ 60v 54v 300w 150w +/ - 1% 1% ultra level tech co., ltd. we supply the power customers need iso9001 www.ultralevel.com.tw tel:+886 - 2 - 29180118 fax:+886 - 2 - 29181465
copy right ultra level tech co., ltd 2015, all right reserved. specifications subject to change without notice. u type (u - chassis only): 5 (l) x 3.2(w) x 1.5(h) inches; weight: 500g. u type (u - chassis with top cover ): 5 (l ) x 3.2(w) x 1.66(h) inches; weight: 550g. ultra level tech co., ltd. we supply the power customers need iso9001 www.ultralevel.com.tw tel:+886 - 2 - 29180118 fax:+886 - 2 - 29181465 ?
copy right ultra level tech co., ltd 2015, all right reserved. specifications subject to change without notice. f type (u - chassis with top built - in fan ): 5 (l ) x 3.2(w) x 2(h) inches; weight: 600g. e type (enclosed with rear side built - in fan): 6.5 (l) x 3.2(w) x 1.6(h)inches; weight: 650g. ultra level tech co., ltd. we supply the power customers need iso9001 www.ultralevel.com.tw tel:+886 - 2 - 29180118 fax:+886 - 2 - 29181465 81.28 165.10 114.30 6.35 68.58 [2.70] 44.52 64.77 8.26 40.64


▲Up To Search▲   

 
Price & Availability of PRL0801E-24

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X